Socket PCB
1.
Solder the 12 sockets to the 12 Socket pcbs,
socket sits on it’s silkscreen footprint
Final Assembly
1.
Present the pcb to the panel, and bolt the two together using the washers and nuts
for the pots and switch
2.
Cut 12 pieces of male header to be 6 pins wide. Place the long end of each into the
12 female headers.
3.
Present each socket pcb assembly to the main pcb, bolt into place, making sure that
the male headers line up with their places on the socket pcbs. Solder the male
headers to the sockets pcbs.
Calibration
•
Bias:
Adjust Bias trimmer to sweet spot, ie a nice clean undistorted VCA output with
no thunk when a snappy ADSR is applied to a CV input. I do this without any audio at
the inputs. The chances are that that the sweet spot is around the mid position.
•
Lin and Exp:
you can set these up to output matching voltages, however, in reality
it’s better to set them up to perceived volume.
RDH 27/07/19
http://www.frequencycentral.co.uk/
