Frequency Central Bartos Flur Rev(2) Скачать руководство пользователя страница 2

Страница: 2 / 4

Main PCB

Populate the Main PCB as shown on the silkscreen, starting with the lowest profile
components, so:



Resistors



IC sockets



Non-electrolytic capacitors, voltage regulators



Power header and expansion header



Electrolytic capacitors - there’s an error on the silkscreen, the electrolytic polarities
are obscured, see photo:

Finally, cut 2 male header strips to the correct lengths (16, 16) and solder to the PCB so that
the long legs stick out of the rear of the PCB.

Содержание Bartos Flur Rev(2)

Страница 1: ... 91K x 1 100K x 6 200K x 1 270K x 2 470K x 1 100nF poly box x 1 10uF electrolytic x 2 100uF electrolytic x 2 Bartos Flur PIC x 1 TL084 x 1 1n4148 x 1 78L05 x 1 78L09 x 1 3mm red LED x 8 B100K x 2 All pots are 9mm Alpha DPDT Toggle on on x 1 Power header Male header strip Female header strip Kobiconn sockets x 11 ...

Страница 2: ...on electrolytic capacitors voltage regulators Power header and expansion header Electrolytic capacitors there s an error on the silkscreen the electrolytic polarities are obscured see photo Finally cut 2 male header strips to the correct lengths 16 16 and solder to the PCB so that the long legs stick out of the rear of the PCB ...

Страница 4: ...up all the nuts it s worth checking that the LEDs will fit smoothly through the holes before doing this as some can be a little tight if needed a scalpel can be used to shave the holes slightly wider Place the assembly face down push the LEDs into position and solder in place Plug the Main PCB into the Panel PCB you re done http www frequencycentral co uk RDH 17 03 15 ...