36
9.3.
Defrosting
Warm ambient air can get into the multideck. It is very likely when the showcase is
without doors or its door left open. Due to it, the evaporator can frost. Evaporators
must be regularly defrosted using programs set in the control. During the defrosting
refrigeration is not run.
9.4.
Cleaning
The multideck must be regularly cleaned, as food products are sensitive to bacteria
and microorganisms.
Regular cleaning:
•
The multideck must be cleaned at least once a week. If needed, when
contamination is detected, the multideck must be cleaned more often.
•
Multideck inner space, shelves, interior and exterior plastic, and glass parts of
the multideck must be thoroughly cleaned as well as the floor where the
multideck is installed, must be washed.
•
Washing of the plastic parts must be performed using warm water and a non-
abrasive cleaning agent dedicated for plastics.
•
Metal components must be cleaned using warm water and a non-aggressive,
corrosion-free cleaning agent. After washing, it is necessary to remove any
moisture residue and to dry up the surface. Chromed surfaces must be cleaned
with suitable cleaning agents. After cleaning, they must be dried up with a soft
cloth that does not leave dust.
•
Painted components must be cleaned with liquid cleaning agents without
abrasive materials. It is recommended to use special detergents purposed for
painted surfaces. The surfaces must be well dried up after washing. The paint
damage can cause metal corrosion at the scratch place.
•
Glass parts can be washed using the household window cleaning agents.
•
Some units have a wooden finish. Wood and surfaces of wooden products must
be cleaned dry. Also, wood polishers can be used. If necessary, surfaces can be
cleaned with a damp cloth and then dried thoroughly.
•
Protect electrical installations from moisture during cleaning.
•
It is necessary to regularly check drainage system.
•
Washing the multideck with high-pressure washers is strictly forbidden.
Deep cleaning
Deep cleaning of the multideck must be performed once every 4 weeks. The
multideck must be cleaned and disinfected to eliminate pathogenic microorganisms.
•
Make sure that defrosting is in progress.
•
Remove the products from the multideck, and temporarily place them in the
freezer compartment.
Содержание JUPITER H8
