freightliner Run Smart ARGOSY, Руководство пользователя

Страница: 141 / 166

Sulfide Stains
Sulfide compounds, such as those found in eggs and
some canned goods, can stain after prolonged con-
tact with vinyl. These stains can be removed by plac-
ing a clean, unprinted piece of cloth over the spotted
area and pouring a liberal amount of 6 percent hy-
drogen peroxide onto the cloth. Allow the saturated
cloth to remain on the spot for 30 to 60 minutes. For
stubborn spots, allow the hydrogen-peroxide satu-
rated cloth to remain on the area overnight. Use cau-
tion to prevent the solution from seeping into the
seams, or it will weaken the cotton thread.
Nail Polish and Nail Polish Remover
Prolonged contact with these substances causes per-
manent damage to vinyl. Careful blotting immediately
after contact minimizes damage. Do not spread the
liquid during removal.
Shoe Polish
Most shoe polishes contain dyes which penetrate
vinyl and stain it permanently. Shoe polish should be
wiped off as quickly as possible using naphtha or
lighter fluid. If staining occurs, try the procedure used
for sulfide stains.
Ball Point Ink
Ball point ink can sometimes be removed if rubbed
immediately with a damp cloth, using water or rub-
bing alcohol. If this does not work, try the procedure
used for sulfide stains.
Miscellaneous
If stains do not respond to any of the treatments de-
scribed above, it is sometimes helpful to expose the
vinyl to direct sunlight for up to 30 hours. Mustard,
ball point ink, certain shoe polishes, and dyes often
bleach out in direct sunlight, leaving the vinyl undam-
aged.
Velour Upholstery Cleaning
To prevent soiling, frequent vacuuming or light brush-
ing to remove dust and dirt is recommended. Spot
clean with a mild solvent or an upholstery shampoo,
or the foam from a mild detergent. When using a sol-
vent or a dry-cleaning product, follow the instructions
carefully, and clean only in a well-ventilated area.
Avoid any product that contains carbon tetrachloride
or other toxic materials. With either method, pretest a
small area before proceeding. Use a professional
upholstery cleaning service when extensive cleaning
is needed.
Grease and Oil-Based Stains
Dampen a small absorbent cloth with dry-cleaning
solvent or spot remover. Apply the cloth carefully to
the spot from the outer edge to the center. Pat and
blot the spot with a clean, dry cloth. Repeat several
times, as necessary, turning the cloths so that the
stain does not redeposit on the fabric.
Sugar and Water-Based Stains
Apply water-based detergent or cleaner, working in
circular motions. Pat and blot as dry as possible. Re-
peat, if necessary, before drying thoroughly.
Chewing Gum or Wax
Harden the gum or wax with an ice cube wrapped in
a plastic bag, then scrape it off with a dull knife. Ex-
cess wax can be absorbed by placing a thick white
blotter over the wax and heating with a warm (not
hot) iron. Remove the remainder by using the proce-
dure for grease and oil-based stains.
Mildew
Brush the dry fabric with a soft brush. Sponge with
detergent, and blot. If the fabric is colorfast, dilute a
teaspoon of bleach in one quart (one liter) of cool
water. Apply with a swab, directly on the mildew
stain. Dab repeatedly with clear, cool water, and blot
dry.
Care of Exterior Lights
Clean the headlight lenses by hand only, using a
flannel cloth with mild, non-caustic soap or detergent,
and water.
NOTICE
Do not use a power buffer, paper towels, chemi-
cal solvents, or abrasive cleaners on the head-
light lens. These materials can remove the UV
coating from the surface, resulting in yellowing
of the lens.
Cab Appearance
20.2