freightliner CL112 2015, Руководство по обслуживанию

Страница: 72 / 180

4. Clean the filter element by dipping it in alcohol or
other cleaning solvent. Blow compressed air
through the element (inside to outside) to loosen
surface dirt and to dry the element. If it is not
damaged, the sintered metallic filter element will
last the life of the vehicle.
Wipe out the filter housing with a clean, dry, lint-
free rag. Clean and inspect the O-rings and end
cap. Replace any parts that are damaged.
5. Install the large O-ring, then the filter element
(small end first) into the filter housing.
6. Install the small O-ring in the end cap, then in-
stall the end cap and tighten it until firm.
NOTICE
A leaking air filter or air lines can cause slow or
hard shifting of the transmission, and eventual
transmission damage.
7. Start the engine, and build pressure in the air
system. Check for air leaks at the filter housing
and air line connections; repair any leaks.
Meritor
NOTE: This procedure does not apply to
FreedomLine transmissions.
1. Park the vehicle on a level surface. Apply the
parking brakes, and chock the rear tires.
2. Remove the element from the air filter/regulator
assembly. Inspect the O-rings in the end cap;
replace worn or damaged O-rings. Inspect the
element for fluid contamination. If fluid is present,
replace the element. Inspect the air supply sys-
tem for the source of the fluid, and service it as
needed.
3. Install the element in the filter/regulator assem-
bly.
4. Apply a light coat of silicone grease, or an
equivalent grease to the O-rings in the end cap.
Install and tighten the end cap 10 to 15 lbf·ft (14
to 20 N·m).
5. Build air pressure in the system, check for leaks,
and make any needed repairs.
f260037a 10/05/2016
Fig. 2, Air Filter/Regulator Location (Eaton Fuller
transmission shown)
1
2
3
4
5
6
7
f260052a 10/17/2001
1. Air Regulator
2. Housing
3. Large O-Ring
4. Filter Element
5. Small O-Ring
6. End Cap
7. Plug
Fig. 3, Eaton Fuller Transmission Air Filter/Regulator
Components
Transmission
26
Columbia Maintenance Manual, July 2017
26/4