2
Introduction
The following manual will guide you through the procedure for assembling the Aeroflex panels
and rods. The procedure to takes approximately 1.5 man hours per unit once familiar with the
process, and is necessary for bulk packaged units only. Note that the procedure for installing the
assembled fairing on the trailer is outlined in a separate installation manual.
If we may be of assistance during the pre-assembly or at any time, please give us a call:
TOLL FREE INSTALLATION HELP LINE: 866-464-9464
What You Will Need
The following tools are needed to assemble the Freight Wing Aeroflex Fairing:
1. A 7/16
” wrench with an open end
2. A 7/16
” socket
3. A drill (preferably cordless with a clutch) to tighten nuts with
4. An allen (hex) key set
5. Anti seize lubricant (if needed for stainless hardware)
6.
Barrier tape (2” wide clear packing tape) and a razor (if needed for steel I beams)
7. It is helpful to have a large table
(approx 8’x4’) or elevated surface to work on
Parts List
Freight Wing
Part Number
Description
Qty per
Complete Unit
76-50174-02
Fastener Kit 12B (pre-assembly fasteners)
1
76-50174-01
Fastener Kit 12C (install fasteners)
1
44-50028-00
Hinge, Long (top)
6
44-50029-00
Hinge, Short (bottom)
16
58-50132-00
Panel Right Rear (RR)
1
58-50133-00
Panel Left Rear (LR)
1
58-50134-00
Panel Right Middle (RM)
1
58-50135-00
Panel Left Middle (LM)
1
58-50136-00
Panel Right Front (RF)
1
58-50137-00
Panel Left Front (LF)
1
68-50134-00
Backing Strip (Aluminum)
12
68-50132-00
Support Rod
16
68-50131-00
Clamp Tab
32
68-50133-00
Clamp Sleeve
16
68-50135-00
Square Hinge Washer
24
