7
SHARK CLASSIC TIDE XL 600
Instruction Manual
TO SET THE HEAT TIMER
When setting the heat timer, the S1 TIDE button will be used to increase the digit
and the S2 RESET button will be used to decrease the digit. Holding down either button
will speed up the process.
1. Press the S3 MODE button until it shows the HEAT TIMER display.
2. Press and hold the S4 SET button for approximately 4 seconds. The message “SET HEAT TIMER”
will be displayed and minutes digits will blink. Use the S1 TIDE button and S2 RESET button
to increase or decrease in increments of 5 minutes.
3. Press the S4 SET button to confirm.
NOTE: The heat timer can count up to a maximum time of 35.00 (35 minutes)
TO USE THE HEAT TIMER
1. Press the S3 MODE button until it shows the HEAT TIMER display.
2. Press the S1 TIDE button to start counting down.
3. To stop the countdown, press the S2 RESET button. Press the S1 TIDE button to resume.
4. To reload the heat timer, press the S2 RESET button to stop the counting
and then press S2 RESET button to reset.
5. When the countdown is complete a timer alert tune will be emitted and the backlight will flash.
NOTE: You can leave the timer running while switching to other modes.
The heat timer indicator (graphic) will be displayed on the NORMAL TIME or TIME 2 screen.
NOTE: the heat timer is independent of the timer. Both may be running at the same time.
TO SET THE ALARM TIME
1. Press the S3 MODE button until it shows the ALARM display.
2. Press and hold the S4 SET button for approximately 4 seconds. The message “SET ALARM”
will be displayed and the alarm entry setting will blink. Press the S1 TIDE or S2 RESET button
to toggle between ALARM 1 and ALARM 2.
3. Press the S3 MODE button, the hour will blink (including AM/PM for 12-hour format.)
Use the S1 TIDE button and S2 RESET button to increase or decrease the digit.
4. Press the S3 MODE button, the minutes will blink. Use the S1 TIDE button and S2 RESET button
to increase or decrease the digit.
5. Press the S3 MODE button, the alarm frequency will blink. Use the S1 TIDE button
or S2 RESET button to cycle forward or backward through the frequency options (DAILY, WEEKDAYS,
WEEKENDS, SUNDAY-SATURDAY WEEKLY.
6. Press the S4 SET button to confirm. The alarm will automatically be activated after being set.
NOTE: Both ALARM 1 and ALARM 2 function in accordance to the NORMAL TIME only.
