6
6. Attach the Backrest (10) to the Backrest Frame (5)
with two M6 x 16mm Screws (64), an M6 x 50mm
Screw (69), and an M6 Flat Washer (71).
7
35
13
Slot
36
Knob
5. Attach the Seat (12) to the Seat Frame (6) with three
M6 x 16mm Screws (64).
5
6
7. While another person holds the Upright (13) in the
position shown, connect the Upper Wire Harness (35)
to the Lower Wire Harness (36).
Carefully pull the
upper end of the Upper Wire Harness to remove
any slack from the Wire Harnesses.
Turn the Knob (not shown) on the right side of the
Frame (1) counterclockwise two or three turns to
loosen it. Next, pull the Knob, insert the Upright (13)
into the Frame, and then release the Knob.
Move the
Upright up and down slightly until it locks into
position. Be careful to avoid pinching the Wire
Harnesses (35, 36). Tighten the indicated M6 x
25.4mm Button Screw (79) into the slot in Upright.
79
12
6
64
64
10
5
71
69
64
1
8. While another person holds the Console (16) in the
position shown, connect the wire harness on the
Console to the Upper Wire Harness (35). Insert the
excess wire harness into the Upright (13).
Attach the Console (16) to the Upright (13) with four
M4 x 16mm Screws (73).
Be careful to avoid pinch-
ing the wire harnesses.
Attach the Water Bottle Holder (89) to the Upright (13)
with two M4 x 22mm Screws (91).
16
35
73
91
Wire
Harness
8
13
89
