Freescale Semiconductor NXP DEMO9S08JS16, Краткое руководство пользователя

Страница: 6 / 8

Test Board by Running
Quick Start Application
Now that you have successfully completed the
software and hardware setup, test your board
by running the Quick Start Application pre-loaded
in the microcontroller’s on-chip flash memory.
The programmed application is the HID mouse
software included in the complimentary USB
stack for MC9S08JS16. In this example, the
demo board will work as a mouse.
1. Remove the jumpers on J4.
2. Turn the SYSTEM POWER switch to the
“on” position. The red “Power” LED will
illuminate and the application will start.
3. Connect the provided A to mini-B black
USB cable from a free USB port on your
computer to the mini-AB USB connector
on the board.
4. Your computer will recognize the MC9S08JS16
as a HID mouse device and begin installation
(no user interaction needed). When hardware
installation is complete, the MC9S08JS16
will work as a mouse device. If the “Reset”
button is pressed and held, the PTG1
button works as the left mouse button.
If the Reset button is released, the PTG1
button acts as the right mouse button.
Similarly, the PTG2 and PTG3 buttons can
move the mouse left and up if the Reset
button his held down. When the Reset
button is released, these two buttons can
move the mouse right and down.
5. Now that your board is functional, try out
the labs discussed in the DEMO9S08JS16
Labs document (DEMO9S08JS16LAB)
included in the “Training” section of the
DVD. These labs will guide you step
by step through all the HID, CDC class
and USB bootloader examples included
in the complimentary USB stack for
MC9S08JS16.
Connect Board to Computer
USB driver installation is a one-time required
step, to be completed after CodeWarrior
installation.
1. Remove DEMOJM baseboard and
DC9S08JS16 daughter card from
anti-static bags.
2. Plug in the MC9S08JS16 daughter card to
DEMOJM baseboard, aligning pin 1 arrows.
3. Connect the provided A to B gray USB cable
from a free USB port on your computer to
the USB connector on the board.
4. The operating system will recognize your
board as new hardware and will prompt you
to install the USB drivers. Choose the
recommended option to install the software
automatically. USB drivers for your board were
pre-loaded in the CodeWarrior installation.
5. Follow on-screen instructions until all USB
driver installations are complete. The green
USB LED on the board should illuminate.
1. Insert the provided DVD into the computer. A menu
will appear.
2. Click “Install PEmicro Toolkit.” This will launch the
toolkit installer.
3. Follow the on-screen instructions to complete the
installation.
For more information on the PEmicro Embedded
Multilink Toolkit read the DEMO9S08JS16
User Manual (DEMO9S08JS16 UM.pdf) included
in the “Documentation” section of the DVD.
For new and upgraded utilities to the
PEmicro Embedded Multilink Toolkit,
visit www.pemicro.com.
STEP
7
STEP
6