Freescale Semiconductor Microcontrollers, Руководство пользователя

Страница: 583 / 892

ColdFire V1 Full Chip Simulation Connection
583 Microcontrollers Debugger Manual
Manual Configuration: The Memory Configuration dialog box lists an entry for each
memory block. You can modify such entries without restriction.
NOTE To simulate an absolute file generated in Freescale object file format, you must
open the Memory Configuration dialog box, set the
auto on load mode, then
add a new RAM segment. The start and end addresses of this segment must
match the associated
.prm
file. Once you close the dialog box, you can load
your application and start a simulation.
Open Memory Block
Click the Open button to load a memory block file. The Open Memory blocks standard
dialog box appears. Select a memory map file, then click the OK button. The dialog box
closes, and the system loads the memory block file.
The Mode combo box changes to indicate the mode contained in the memory map file.
The list box lists the memory blocks loaded from the file, starting from the first memory
block. Appropriate data appears in the fields
Name , Type , Start , End , Wait state , Bus
width and Access Details .
Save Memory Block
Click the Save button to store the current memory blocks configuration. The Save
Memory blocks standard dialog box appears. Enter a file name, then click the OK button.
The dialog box closes, and the system stores the memory block configuration into the file.
Memory Check Options
The Memory Check group box consists of three checkboxes, all checked when you bring
up the Memory Configuration dialog box:
• Stop if no memory — Check this box to have the FCS stop on an access to non-
existent memory. Clear this checkbox to prevent the FCS from stopping.
• Stop on read undefined — Check this box to have the FCS stop on a read of
undefined memory. Clear this checkbox to prevent the FCS from stopping.
• Stop on write protected — Check this box to have the FCS stop on a write to read-
only (write-protected) memory. Clear this checkbox to prevent the FCS from
stopping.
Memory Configuration Module Startup
Memory configuration is a dynamically loaded facility. That is, the new entry Configure
appears in the Simulator menu upon loading of the FCS (the Full Chip Simulation dll).
Selecting Configure opens the Memory Configuration dialog box, so that you can
configure memory.