2.Charging Circuit Fuse:
One fuse protects your scooter charging circuit from receiving an overload of
electrical current. The fuse used in the scooter is the same type which is found on
automobiles. In the unlikely event that a fuse should "blow" and needs replacing.
Use only a fuse of a 10 amp rating. Please note this size of fuse has been selected
to give your scooter the best protection without premature fusing.
Locate and lift the fuse block on its wire, lift up the fuse lid and withdraw the "red"
fuse. Replace the blown fuse with recommended 10 amp (pink) fuse, close fuse lid
and replace fuse block.
The scooter only uses a fuse of a 10 amp rating. Please note this size of fuse has
been selected to give your scooter the best protection without premature fusing.
！
Warning:
Do not
use fuses with a higher rating than 10 amps as this
may cause permanent failure to the wiring and wiring connectors or
personal injury. For access to a fuse remove the four screws located in
the rear body cover, and then lift the cover.
24