BATTERIES & BATTERY CHARGING
1.Battery Installation:
Your scooter is equipped with two maintenance free 12 volt 50Ah batteries. The
batteries are linked together by wiring cables to supply the electronic system with 24
volts of power.
(1) Connect the labeled positive (+) wire to the positive (+) terminal of the battery,
with the screw, nut and washer provided.
(2) Connect the labeled negative (-) wire to the negative (-) terminal of the battery,
with the screw, nut and washer provided.
(3) Repeat this procedure on the second battery making certain the plastic red/black
terminal covers are secured over each terminal.
(4) Sit on the seat and switch on your Scooter, the battery meter will now move to
show the state of charge in the batteries and your Scooter is ready to drive.
Batteries circuit diagram
2.Battery Charging:
Your scooter has a lot of power. To
ensure it works to its full potential you
must maintain both batteries on full
charge. Nightly recharging, after use,
will help you to give them a longer
life and will ensure your scooter is
always ready to go when you are. Only
use the charger supplied with your
Scooter; other makes of charger may
permanently damage your batteries
and would invalidate the Guarantee.
！
Warning:
It is imperative that the two batteries are connected correctly
to prevent a short circuit between the two batteries. When first
installing the batteries follow these assembly instructions.
22