14
14. Attach a 25mm Snap Ring (39) to one end of
the Pivot Axle (53).
Identify the Pivot Leg (51) and orient it as
shown.
Have a second person hold the round tube on
the Pivot Leg (51) and two Plastic Washers (56)
inside the bracket on the Pivot Arm (52).
Insert the Pivot Axle (53) into the bracket, the
Plastic Washers (56), and the round tube.
Make
sure that the Large Pin (94) is inserted into
one of the holes in the Pivot Leg Selector
Plate (50).
Attach a 25mm Snap Ring (39) to the other end
of the Pivot Axle (53).
14
56
38
51
50
56
15
39
39
94
52
51
82
87
88
60
40
48
15. Press the end of the Cable (40) as far as possi-
ble into the socket on the Cam (48).
Loosen the two M6 x 15mm Socket Screws (88)
in the Bar Clamp (87) on the indicated end of
the Pad Bar (60);
it is not necessary to
remove the Socket Screws.
Then, slide the
Bar Clamp and the Clamp Cover (82) off the
Pad Bar.
Insert the end of the Pad Bar (60) through the
Pivot Leg (51).
Slide the Bar Clamp (87) and the Clamp Cover
(82) onto the Pad Bar (60). Then, tighten the
two M6 x 15mm Socket Screws (88).
Rotate the Clamp Cover (82) so that the open-
ing is facing the floor.
53
