Freefly RADIAN, Инструкция по эксплуатации

Страница: 9 / 22

P16
The wiring for the modules will depend on what type of receiver system you will use (PPM, PWM, S.Bus or Spektrum).
PWM wiring will result in a more cluttered wiring layout; therefore, we recommend using S.Bus, PPM, or Spektrum
over PWM. When using S.Bus, PPM or Spektrum, you are able to daisy chain the modules such that there only needs
to be a connection from the mount receiver to the pan module. The pan module will then pass signal along to the roll
module, which will pass it along to the tilt module. This allows for minimal wiring mess. Refer to the Pinout Diagram
in Image 1 for the proper servo connector installation. If you are using PWM input (standard receiver), you will need a
connection from each slew control channel to the corresponding module, as well as the mode input control from each
channel. Note that PWM will require additional servo extensions (not included).