1.
Place all parts in a cleared area and remove the packing materials from the spa shell; do no dispose of the packing
materials until assembly is completed and the spa is in operation.
2.
Assembly requires two people and the spa needs to empty so the Foot Pedals can be positioned underneath the spa.
Foot Pedals should be placed under the spa just past the radius corner equally on both sides.
3.
During assembly, make sure that all parts are oriented as shown in the drawings. Read each assembly step before
you begin. IMPORTANT: Self tapping screws need to face away from the spa/spa cover - see illustration at the bottom
of page 4. Side pivot arms have a dimple indicating were the screws should be placed.
4.
Tighten all parts as you assemble them, unless instructed to do otherwise.
SET-UP AND ASSEMBLY:
Step 1:
Thread Pivot Arm (PA) Bolts A into center hole (#M12 Nut) of Mounting Bracket, and Insert Large Washer to PA Bolts B
(Fig 3-2) and thread into corner hole (#M12 Lock Nut) of Mounting Brackets.
Step 3:
Slide left and right Foot Pedals in place to the appropriate sides of the spa.
This end to
mounting
brackets
Pivot Arm
Bolt B
Pivot Arm
Bolt A
Identify Right Mounting bracket and Left Mounting
Bracket. Repeat Step 2 to 4 for both right and left.
Step 2:
Locknut
Bolt Nut
(Fig 3-1)
Pg. 3, Rev. 2, 4/21/14
Pivot Arm Bolt A
Pivot
Arm Bolt
B
Large
Washer
(Fig 3-2)
Left
Right
Left
Right