![background image](http://html1.mh-extra.com/html/freeflight/86943-00/86943-00_installation-manual_2330088007.webp)
FWF-125 Serial to WIFI Transceiver
Installation Manual
87330, Rev D.
FreeFlight Systems Proprietary Information
– see Page 1 for details
II-1
SECTION II INSTALLATION
2.1 GENERAL
This section provides general information for installing the FWF-125 into an
aircraft. This section contains mounting dimensions, pin outs, and interface
details pertaining to installation. Adherence to these installation procedures and
information will assure satisfactory system performance.
2.2 UNPACKING AND INSPECTING EQUIPMENT
Exercise care when unpacking each item. Visually inspect each item for evidence
of damage incurred during shipment. If a damage claim must be filed, save the
shipping container to substantiate the claim. When the equipment and the
installation kit have been inspected, save the packing material and container in
case the unit is to be stored or reshipped. Refer to section 1.5 for equipment and
optional parts supplied.
2.3 EQUIPMENT MOUNTING
The FWF-125 is designed for mounting in any convenient location in the cockpit,
the cabin, or an avionics bay.
The following installation procedure should be followed, remembering to allow
adequate space for installation of cables and connectors.
Select a position in the aircraft that is not too close to any high external
heat source. (The FWF-125 is not a significant heat source itself).
Avoid sharp bends and placing the cables near aircraft control cables.
Secure the FWF-125 on a flat surface according to the FWF-125 mounting
requirements illustrated below in Figure II-1.