v3.2-F6
FreedomAlert
®
7
Installing the Batteries
Pendant - small white batteries
. The Pendant requires one of the white/
Li-Ion (Lithium Ion) batteries at any given time. The pendant should be able
to run up to 4 months on a fully charged battery. The second battery is to be
charging in the Base unit when not being used in the Pendant. There is no
problem of over charging while in the base charger.
To install the battery - unscrew the battery cap of the Pendant. Install the
battery with the negative side up facing the cap. Screw the cap back down
snuggly on the Pendant.
The Pendant Batteries are shipped from the factory with a partial charge – and
will only standby a short period of time. Your unit has 2 pendant batteries
and it is recommended to exchange the battery that is in the base charger
with the battery in the pendant after the first day of use. This will assure the
battery in the pendant is fully charged and will standby several months before
needing to be exchanged/charged again.
You can check the battery status at any time by simply pushing the gray bat-
tery test button on the back of the Pendant for a second.
Place the extra Pendant battery into the front charging area of the Base unit
so that it will charge and be ready when its time to swap the batteries around.
The LED on the right side indicates the charging status:.
LED OFF - No battery installed in charging port
LED RED - Battery is charging
LED GREEN - Battery is fully charged
NOTE: These white batteries are very special batteries that are not available
at your local store. See Specification on page 35 for more details, or contact
LogicMark to purchase replacement batteries. You can also purchase them
on-line at www.PrimaryVolt.com
LED
