6
For bikes with standard 100mm forks installation is very
simple:
1. Just fi t the motorised wheel to the bike (cable exiting from
the left as you sit on the bike). Ensure that the axle (with
straight edges) fi ts snugly into fork and that the axle can’t
turn or move in the fork drop-out. Make sure you fi t the
torque washer with the lug fi tting into the hole on the fork.
2. Install the throttle on the right handlebar by using a hex
screw to loosen and then tightening when fi tted.
3. Th
e battery and controller go in a front or center mounted
bag.
4. Connect the red plugs (sparking is normal) and the big
black plugs together and notice that the red, yellow and
green lights on the throttle light up. You’re good to go.
5. When you’ve fi nished riding or when the battery is low
(green light does not stay lit) plug the charger into the
mains and connect the battery using the red plugs. Th
e
battery has no memory and does not need to be fully dis-
charged. It is advisable to disconnect the battery once its
fully charged
Simple Instructions on Installation & Use
11
NB: Th
e controller cuts off the motor once the battery volt-
age drops to 30V However, the controller continues to draw a
small amount of current regardless of whether its connected to
the motor or not and if left connected for a prolonged pe-
riod of time (several hours or more), it may drain the battery
completely, eff ectively rendering it useless. For this reason we
recommend disconnecting the battery from the controller
whenever its not in use.
