Humidity function (purified water)
Cleaning the purifier
Check the tank for liquid before turning on the Humidification function.
The purifier may be dam- aged if the function is turned on with sufficient
liquid in the tank. (If the influence of atomization is poor, it needs to
change the cotton swab regularly.)
1. The atomizer module is fixed in place with magnets. Gently lift it up to
remove.
2. Fill the liquid tank to the marked level and place it back into the
device.
3. Put the atomizer module back in to the purifier carefully. The
registration mast and groove should be in alignment.
While shifting the purifier, make sure that the power plug has been
unplugged.
Unplug the power cord before cleaning the purifier.
Do not immerse this purifier in water or any other liquid.
Do not clean any part of the purifier with abrasive, corrosive or flammable
cleaners such as bleach or alcohol.
Only pre-filters can be cleaned with water.
Cleaning the purifier
Clean the purifier inside and outside regularly to prevent dust build-up.
1.
Use a soft, dry cloth to wipe the dust off the body
2.
Clean the air quality sensor inlet/air outlet with a soft dry cloth.
Cleaning the air quality sensor
Clean the air quality sensor every 2 months to ensure that the purifier is
operating at optimum performance levels. If the purifier is used in a dusty
environment, clean it frequently.
1. Use a soft brush to
clean the air quality
sensor inlet or outlet.
2. Remove the
protective cover of the
air quality sensor.
3. Use slightly wet cotton swabs to clean the sensor, air inlet and
outlet.
5. Replace the protective cover of the air quality sensor.
Note:
While indoor humidity is very high, condensate may form on the sensors
leading to poor air quality indication. In this case, you must clean the air
quality sensor or use any manual speed setting.
10
11
