Freedom Showers Flat Top Slot Series, Инструкция по установке

Страница: 4 / 4

INSTALLATION INSTRUCTIONS
Silhoue tt e
Shower Seat
LIFESTYLE & WELLNESS
®
Page 4
of 4
Diagram A
NOTE:
The seat bo
tt om panel is a tt ached to the aluminum frame at the factory using high-strength VHB tape.
Do NOT a tt empt to remove the seat bo tt om panel from the seat frame as it may cause severe damage to the seat.
To ensure proper and safe installa ti on, the shower seat should not shi ft in any dir ecti on on the moun ti ng surface.
Hardware Provided:
(6) #14 Flat Head Phillips sheet metal screws 2-1/2” length.
Tools required:
Marking pencil/pen, level
,
masking tape, power drill, 1/4” Carbide tile drill bits, 3/16” Standard drill bit,
#3 phillips driver, silicone.
THIS COMPLETES THE INSTALLATION OF THE SILHOUETTE SHOWER SEAT.
Step #3
Secure the Seat Moun
ti ng Bracket to the wall
using the (6) #14 Flat Head Phillips sheet
metal screws (supplied by manufacturer)
and screw into the solid wood backing,
star
ti ng with the top two hole loc ati ons.
Do NOT ti ghten the moun ti ng screws
completely un ti l ALL (6) screws are in place.
Step #4
Once all six (6) screws have been
ti ghtened,
install the seat backrest by placing the four (4)
pins (a
tt ached to the backside of the phenolic
seat backrest panel) into the four (4) slo tt ed
key-holes on the seat frame. The backrest
panel should easily slide down approximately
½” un
ti l secure in its normal posi ti on. Make
certain all four (4) pins are engaged in each
key-hole slot.
To remove the seat backrest, slide the
backrest panel up approximately ½” so the
four (4) pins align with the enlarged por
ti on of
the key-hole slots on the seat frame, and pull
the backrest away from the frame.
FREE OM
Showers.com