Freedom Lift Systems Trus-T-Lift 750, Руководство по обслуживанию

Страница: 4 / 10

3 | P a g e
TRUS<T>LIFT™ 750 LIMITED MAINTENACE MANUAL REVISION A, 16AUG2016
3.2.2 Inspect the drive screw
Inspect the drive screw for any irregulari ti es, sharp edges or foreign
objects and dirt caught in the threads. Be sure no damage exists to the
drive screw and that it is en
ti rely clean of debris. Replace screw if
damaged.
3.2.3 Clean and re-lubricate the drive screw
In order to lubricate the drive screw you must remove the main front panel
and a carriage guide frame panel. Use a clean rag to wipe all of the grease
o
ff of the screw. Liberally apply Mobilith SHC-460PM grease on the drive
screw.
3.2.4 Inspect the drive belt
Remove the top cover and inspect the drive belt for wear. A small amount
of black rubber bits below the belt is normal. If there is any signi
fi cant sign
of wear to the belt, replace.
3.2.5 Inspect for surface damage and complete touch ups to coatings
Wear and tear may occur on powder coated steel surfaces resul ti ng in
scratches. Small points of damage can be wire brushed and touched up
with the small touch up paint containers that come with each li
ft RAM
ships out. This will extend the life and cosme ti c look of you li ft and is
par ti cularly important in any environments that are coastal or poten ti ally
corrosive.
3.2.6 Inspect cables
Tears in insula ti on should be patched where possible and if bare wire is
present new replacement cables should be purchased and installed by a
quali
fi ed technician. Consult your RAM dealer for spare parts should they
be required.
3.2.7 Inspect for correct functioning of toe plate – if applicable
The toe plate actua ti on mechanism may be cri ti cal to access and both the
mechanism and the toe plate itself should be examined. If there are any
concerns adjust the mechanism or repair/ replace it.
3.2.8 Re-check platform alignment and clearances
Buildings and construc ti on “se tt les” over ti me and adjustments may be
required to ensure good clearances and alignment of the li ft . Consult the
appropriate sec ti ons of the installa ti on manual or RAM’s technical support
team for guidance.