INSTALLATION INSTRUCTIONS
1222 Instructions 3-9-15.doc
Page 4 of 5
Step 13:
Drill 1/2” hole in previous marked
location.
Lift up on the console to ensure there is
clearance to drill the hole.
Step 14:
Run the power harness that was
connected to the power point into the
½
hole that
was just drilled in the step 13.
Step 15:
Install non-slip Freedom Charge mat to
wireless charging module.
Place the 4 locator pins
in corresponding holes before installing them in the
armrest.
Step 16:
Firmly press mat around LED.
Step 17:
Connect the Freedom Charge plug to the
power harness that was run to the armrest. Pull as
much excess power harness back into the
underside of the console. Remember to leave a
little to reinstall the (2) 10 mm nuts.
Step 18
:
Check to ensure the power harness or
factory wiring is not going to be pinched lower than
the console and reinstall the (2) 10mm nuts.
