Freecom Ultrium Generation 2, Руководство пользователя

Страница: 32 / 36

30
LED
Sequence
Cause Action required
Ready is ON.
The drive is ready for
operation.
None. This is normal.
Ready is FLASHING.
The drive is carrying out
a normal activity (read,
write).
None.
If the drive is upgrading firmware, do not reset or
power cycle it.
Ready is FLASHING fast.
The drive is
downloading firmware.
None.
Do not reset or power cycle the drive.
Ready is OFF, others are
ON.
Firmware is being
reprogrammed.
None.
Do not reset or power cycle the drive.
Clean is FLASHING.
The drive requires
cleaning.
Load the Ultrium cleaning cartridge. See page 21
for supported cartridges and instructions.
If the clean LED is still flashing when you load a
new or known data cartridge after cleaning, call
for service.
Ready is FLASHING and
Clean is ON.
Cleaning is in progress.
None. The cleaning cartridge will eject on
completion.
The cleaning cycle can take up to 5 minutes to
complete.
Tape Error is FLASHING.
The drive believes the
current tape or the tape
just ejected is faulty.
Unload the tape cartridge. Make sure that you are
using the correct format cartridge; an Ultrium data
cartridge or Ultrium Universal cleaning cartridge.
(See page 21.)
Reload the cartridge. If the 'Tape Error' LED still
flashes or starts flashing during the next backup,
load a new or known, good cartridge.
If the 'Tape Error' LED is now off, discard the
'suspect' tape cartridge. If it is still on, call for
service.
gen2 external oem.fm Page 30 Thursday, February 13, 2003 3:02 PM