Rev k
1.
Gather required items
for Cleaning and
Sanitizing. Ensure
f’REAL
!
Brush is in good
condition. If it is not,
replace it with new one.
Notice: Only use f’REAL!
Brush on f’REAL! Blender
3.
Put 2-3 squirts of
dishwashing liquid into
f’REAL
!
Sanitizing Cup
and fill cup about half way
with hot water.
4.
Open blender front door
to access blending chamber
by pulling on metal tab
located under right corner
of door.
Do not turn blender power
off during cleaning and
sanitizing
.
5.
Using clean f’REAL
!
Brush dipped frequently in
Sanitizing Cup with
prepared dishwashing
solution, thoroughly clean
in the following order
:
5a.
First, the top and
underside of metal cup lid;
This is the most important
step in the entire process, so
be sure to do it thoroughly
every time
.
5f.
And last, the interior
bottom area of gray plastic
blending chamber.
(Do this step last to avoid
possible spreading of drain
area material onto other
cleaned surfaces.)
9.
While 2 minute sanitize
cycle counts down, clean
f’REAL
!
Brush and hands
again with dishwashing
liquid to ensure they are as
clean as possible for step
11, and then thoroughly
rinse with warm water.
5b.
Then the top and
bottom of blending disc
and slider;
(Lift cup lid to access
blending disc. Beware of
sharp edges.)
5c.
Then the blending
shaft;
5d.
Then the gray plastic
blending chamber walls
and front door liner;
5e.
Then the clear plastic
flip up doors - top and
bottom, taking care not to
press them fully open
without supporting them,
as this can cause their
return springs to break off;
6.
Close front door firmly.
Blender will automatically
rinse off cleaned
components.
7.
Rinse out and then fill
f'REAL
!
Sanitizing Cup to fill
line with room temperature
water. Add 4 -6 drops of BTF
Iodophor Sanitizer to room
temperature water cup.
Sanitizing solution is still
nearly clear when properly
prepared
.
8a.
Place Sanitizing Cup
with properly prepared
sanitizing solution in
blender cup holder.
8b.
Press and hold both
“Less Thick” and “More
Thick” buttons for 5
seconds to begin sanitize
cycle.
10.
When sanitize cycle
ends, remove Sanitizing
Cup from cup holder, and
open front door of blender
again.
11 a & b.
Use cleaned
f’REAL
!
Brush dipped in
Iodophor sanitizer solution
from Sanitizing Cup to
thoroughly apply sanitizing
solution to underside and
top of metal cup lid like
shown in Step 5a.
12 & 13.
Pour remaining
sanitizing solution down
blender’s internal drain
located in gray plastic
blending chamber. Then
close front door firmly.
14.
Rinse f’REAL
!
Brush
and Sanitizing Cup
thoroughly with hot water.
Allow to dry and save for
next day’s use.
f’REAL! Blender Cleaning and Sanitizing Instructions
2.
Thoroughly wash hands
with soap and warm water.
