ICA900 Rev150324
6
Install Speaker Box
The speaker box is mounted with a bracket or to the surface with a feed through
hole for the cable.
Bracket Mount
Note:
The mounting bracket can be removed by unscrewing the adjustment
knobs at the side of the control module.
1. Measure and mark mounting location for speaker box bracket. Refer to Figure
2 for layout and dimensions.
2. Drill four mounting holes (clearance or tapped) for mounting 10-32 hardware.
3. Place mounting bracket in position and secure with four screws.
4. If bracket was removed from box, place box in position and install rubber
bushings and mounting knobs.
5. Connect the cable. Provide enough slack in the cable for the speaker box to be
adjusted as needed. (Refer to Wiring Section).
Surface Mount
Note:
At the rear of the box there are four 10-32 blind tapped holes to accept
the mounting screws (1/2 to 5/8 inch deep). Ensure that the mounting
screws do not bottom out in the hole.
1. Measure and mark mounting location for speaker box cable hole and mounting
screw holes. Make sure there is clearance behind the panel before drilling holes.
Refer to Figure 2 for layout and dimensions.
2. Drill a 3/4" hole for the cable and four clearance holes for 10-32 mounting
screws.
3. Place speaker box in position and secure with four screws.
4. Connect the cable to the control module. (Refer to Wiring Section).
