suggested to use Method B to install L-shaped support
(1). The preferred method is: drill two circular holes with
diameter of X mm and depth Y mm, and use two
expansion tubes and grub screws to fix U-shaped
fastener (5) on the wall, then use two screws to fix
L-shaped support (1) on the U-shaped fastener. But
before do this, do not forget to connect plug (4) with
socket (3) as shown in the above figure:
3. Fix the lamp
a
．
Connect power wire to the lamp:
After ensuring the
L-shaped support is well suspended on the wall, insert the
plug (2) of the built-in wire into the socket (1) on the top of
the lamp (3):
b. Fix lamp:
lift the lamp (3) up so that the upper part of the
plug (2) and its wire can enter into the hole of the hold-nut
(2), and turn the hold-nut (2) to let it tightly fit the thread of
the upper part of the lamp until the lamp and L-shaped
support to be fixed as a whole. Meanwhile, adjust the
direction of the lamp until it is satisfied.
Note:
#1.
The hold
nut must be screwed tightly; otherwise, the waterproof
effect of lamp holder will be seriously affected.
#2.
The
lamp holder is fragile, and damage could result from falling
on the ground.
c.
Turn the lamp pendant (4) to fix it with the thread under
the lamp.
4. Power on and examination
a
．
Power on:
connect the plug (5) of power wire (7) with
the socket (8) of adaptor (8). If the power wire (7) is not long
enough, add extended wire (9) between those two and
connect (5) and (6), (7) and (8) separately. After that,
connect the adapter (8) with main power supply.
b. Examination:
there is a switch at the bottom of the lamp
(3) (see the following figure). Turn on the switch to left side,
the lights should be twinkling, snow flying around, and
music playing. If the above are not functioning, check
whether the
connections are properly tightened. You can
also turn the switch to right side to turn off the music.
5. Attention for Rainproof
If the lamp is used outdoor, please pay special attention:
a.
Please fix the hold-nut at the top of lamp securely,
otherwise the rainproof effect will be seriously affected!
b.
All connection points 1, 2, 3, 4, 5, 6, 7 and 8 must be
screwed securely to avoid water and electricity leakage.
c.
The adapter itself is not waterproof, but is required. To
ensure that the connectors between adapter and main
power work properly place this indoors free from rain and
snow, so as to avoid the electricity leakage or electric
shock risk!
d.
The end of L-shaped support is arranged with drip hole,
and this hole should be unobstructed;
e.
The lamp should be kept vertical and avoid inclined to
ensure the water drains properly.
