aPbox Installation and Operations Manual
19
Follow the steps to make AC Power Connections:
Step 1
Run the grid (or an equivalent AC power source) wires and PV wires through the cable
entry holes on the aPbox and pull them into the aPbox enclosure. Mark an appropriate
length for later stripping.
Step 2
Pull the wires out of the aPbox enclosure, cut off the wires from the marker point and
strip the ends according to Table 1.
Step 3
Insert the wires into the corresponding terminal lugs as shown in the following figure.
Tighten the lugs according to Table 1 above.