12
Locking
Wheel Nut
Remover Guide
Index
Blade A and Wheel Nut Selection
2
Blade B and Wheel Nut Selection
4
Blade C and Wheel Nut Selection
6
Jaguar / Range Rover Key
8
Assembly
10
Instructions for Use
12
Using an Impact Driver
14
Using a Breaker Bar
14
Hints & Tips
15
Parts list
16
1
3
A
6
5
B
3
Note
Test hardness with
centre punch
Tip
Line blade tips with
holes where
possible
B
4
B
6
B
7
B
8
B
11
B
12
Tip
Line blade with
holes
A
1
A
2
A
3
A
4
A
5
A
8
A
10
Note
Ordinary nut but
with rounded
corners
Special Tip
Cut through lock with
ordinary chisel inside
the outer shroud
before using blade A
Tip
Use centre punch in
centre for mandrel
Tip
Ensure tool on centre
using c/punch and
mandrel
10
Assembly
1
2
Separate Outer Shroud from Tool Body
Select the correct Blade
to suit locknut/stud.
See pages 2-9
When using Blade A
if the inner shroud will fit over
Locknut place onto Blade as below – this will help keep
tool on centre.
7
16
14
B
2
B
13
A
9
Large 4 x 4 nut
Instructions For Use
WARNING
Blades A or B must not be used on hardened nuts or
studs. Using the centre punch provided test the locknut to be
removed for hardness.
If the centre punch makes a pop mark
without deforming, proceed as per
instructions. But if the punch blunts -
DO NOT USE BLADES A OR B AS
DAMAGE TO THE BLADES WILL RESULT.
Make sure that the rest of the wheel nuts
are all fitted and tightened.
Where possible test in centre of nut face.
HOLD THE TOOL FIRMLY ONTO THE LOCKNUT FACE, INLINE
AND ON CENTRE.
Ensure blades are firmly in contact to prevent bounce against
the nut face. Build-up the force of impacts gradually onto
the tool with a 3lb club hammer until
the teeth are embedded into the end
face to allow a solid grip.
Technique is the answer not brute
strength!
Trust the tool to do the job.
OUTER SHROUD
TOOL BODY
(A)
USING AN IMPACT DRIVER
push in & twist
Using the Impact Driver in the
approved manner, ensure the Blade is
still located into the ‘grooves’ – apply
inward and anticlockwise-rotation
pressure to the Impact Driver before
each strike with a 3lb club hammer.
Only use the one directional high
torque impact driver supplied with
the Locking Wheel Nut Remover Kit.
(B)
USING A BREAKER BAR
Breaker Bar - Push in and down.
If the tool slips recut and try again.
TIP
- Support the tool with a small
jack, get someone to push down on
the bar, at the same time you
hold-push the tool to the wheel.
Do not lift the tool
REMEMBER - It’s easy if you are doing
with the jack!
it right! Simply - DRIVE IN / TWIST OFF
Fig: 1
The end that best locates in the centre
piece of the locknut should be used.
Fig: 2
Once the correct end is determined,
insert the Blade C into the tool body
and re-fit the Outer Shroud.
Fig: 3
Insert the assembled tool into the
wheel recess and locate tool into
locknut pattern.
Fig: 4
A typical example of a “moulded”
Blade C. For best results, ensure Blade
C is cut to a minimum depth of 3mm
and where possible always use high
torque Impact Driver.
