Franklin Wireless S600 Скачать руководство пользователя страница 2

 

2

FCC Regulations: 
 

z

This device complies with part 15 of the FCC Rules. Operation is subject to the following 

two conditions: (1) This device may not cause harmful interference, and (2) this device must 
accept any interference received, including interference that may cause undesired operation. 
 

z

This device has been tested and found to comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. This equipment generates, 
uses and can radiated radio frequency energy and, if not installed and used in accordance 
with the instructions, may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular installation If this 
equipment does cause harmful interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures: 
 
-Reorient or relocate the receiving antenna. 
-Increase the separation between the equipment and receiver. 
-Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected. 
-Consult the dealer or an experienced radio/TV technician for help. 
 
Changes or modifications not expressly approved by the party responsible for compliance 
could void the user‘s authority to operate the equipment. 
 

z

The antenna(s) used for this transmitter must not be co-located or operating in conjunction 

with any other antenna or transmitter. 
 
 

4

RF Exposure Information 

 
This device meets the government’s requirements for exposure to radio waves. 
This device is designed and manufactured not to exceed the emission limits for exposure to 
radio frequency (RF) energy set by the Federal Communications Commission of the U.S. 
Government. 
 

z

This device complies with FCC radiation exposure limits set forth for an uncontrolled 

environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure 
limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal 
operation. 

 
 
 
 
 

I. Functions and Usage 

 

Содержание S600






Отзывы: