23
1.
Unplug the ice maker or disconnect power.
2.
Remove the 2 screws on the front cover and
gently pull it off.
3.
Locate the condenser filter. This can be lifted out and
cleaned with a brush or flowing water.
4.
Remove dirt and lint from condenser fins and the unit
compartment with a brush attachment on a vacuum
cleaner.
5.
Put back the filter and reassemble the front cover.
6.
Plug in the ice maker or reconnect power.
Water Distribution Tube Cleaning
When you find that the ice cubes are incompletely formed or the output of ice cubes is low, the
water distribution tube may be blocked. Set the Power switch to OFF, rotate the water
distribution tube, and locate the holes in the distribution tube. Using a toothpick or similar tool,
dredge the holes, then rotate the water distribution tube back to its original position. If the tube is
badly blocked, clean it as follows:
1.
Shut off the water supply.
2.
Disconnect the water hose from the distribution tube.
3.
Lift the right side up, then remove the distribution tube.
4.
With a brush, clean the tube with a dilute solution of warm water and a mild detergent such as
dishwashing liquid. After removing the dirt and lint from the surface, rinse the tube with clean
water.
5.
Replace the distribution tube
6.
Reconnect the water supply.
Ice-Making System Cleaning
Minerals that are removed from water during the freezing cycle will eventually form a hard,
scaly deposit in the water system. Cleaning the system regularly helps remove the mineral scale
DO NOT touch the condenser fins. They are sharp and can be damaged
easily.
Condenser
surface
Содержание FIM35OD
