Franke FWD 1400-6EI, Руководство пользователя, Страница: 11 / 32

Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to
O .
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 8 .
At the end of the programme, the door is re-
leased and can be opened. Turn the pro-
gramme selector dial to
O to switch the ma-
chine off.
Remove the laundry from the drum and care-
fully check that the drum is empty. If you do
not intend to carry out another wash, close
the water tap. Leave the door open to pre-
vent the formation of mildew and unpleasant
smells.
Stand By : If your laundry is not removed
within 10 minutes after the programme is fin-
ished, the back light of the display switches
off and the energy saving system will be en-
abled. Only the pilot light of the button
8 is
blinking to indicate that the appliance has to
be switched off. By pressing any button the
appliance will come out from the energy sav-
ing status and you can set another pro-
gramme or switch the appliance off.
Use - Drying
Drying only
Warning!
The recommended load size is 3 kg for cot-
tons and linen, and 1,5 kg for synthetic items.
By pressing Drying Time button it is also
possible to dry up to 4 kg of cotton items
(see the «Drying Programme » table).
Warning!
The water tap must be open and the
drain hose must be positioned in the
sink or connected to the drain pipe.
1. Load the laundry.
2. Select a spin cycle at the maximum spin
speed allowed for the type of laundry in
order to obtain the best drying perform-
ances.
3. Select the drying programme for Cottons
or Synthetic in the Drying sector of the
programme selector dial.
4. If you wish to select a timed drying, press
button 5 until the time you want appears
on the display (see the «Drying Pro-
gramme» table). Every time you press this
button the drying time increases by 5 mi-
nutes.
Note!
The programme time will automatically
increase by some minutes.
5. Press button 8 to start the programme.
After the programme has started, the
time remaining is updated every minute.
Note!
The different type of cottons (towelling,
sheets, shirts, and so on) or any laundry
items rolling up during the spinning phase
may result in partial dryness. In the ex-
ceptional case that at the end of the cycle
the laundry remains slightly wet, we sug-
gest that you unfold the rolled up items,
redistribute them evenly in the drum and
select an additional drying cycle of 20-30
minutes.
6. At the end of the programme, the buzzer
sounds and three blinking « 0.00 » appear
on the display and the pilot light 9 is on to
indicate that the door is locked.
The last 10 minutes of the drying cycle
correspond to an anti-crease phase. Dur-
ing this time the door is locked and the
display keeps showing three flashing ze-
ros «
0.00 ».
If you wish to open the door before or
during the anti-crease phase or to inter-
rupt it, press any button or turn the pro-
gramme selector dial to any programme
position (except
O ).
7. Turn the selector dial to the O position to
switch the machine off.
8. Remove the laundry.
Automatic washing and drying (NON-
STOP programme)
For NON-STOP programmes, the recom-
mended load size is 3 kg for cotton and 1,5
kg for synthetic.
11