F3D Operating Manual
Page 4
1
Installation
(Model F
3
D 2.0 Dual Lane Model)
1 Uncrate the Unit
§
Using a large screwdriver and/or prybar,
loosen and remove the wooden crate top.
§
Loosen and remove the crate front panel. Be
careful not to scratch the dispenser
s cabinet
with your tools.
§
Remove the carton of accessories and set
aside.
§
Loosen and remove the crate rear panel.
§
Pull the crate side panels apart. The wooden
cross-members stay attached to, and come
out with, the side panels.
2 Slide Unit Out
You
ll need the help of one or two people to
finish uncrating.
§
With a person on each side of the unit, grasp
the dispenser at the sides.
§
Keeping the crate bottom stationary, slide the
unit toward the front. Use a gentle rocking
motion as needed.
§
When the front wheels are on the floor, keep
pushing the unit forward until all four wheels
are off the crate bottom.
Caution! The crate is built to allow the unit to slide out from the
front ONLY. Pushing toward the rear may cause the unit to tip over.
§
Peel protective white adhesive film from all stainless steel surfaces.
