Franke 2000101096, Инструкция по установке и эксплуатации

Страница: 9 / 84

- 9 -
ZMI
_001_
2000
1010
96-A
Q
UA50
2_#S
EN_#A
QU_#V
5.
fm
16. Replacing the Plastic Hose
16.1 Remove the cover plate (see Chapter 15. ).
16.2 Press the ring in the arrow direction.
16.3 Pull out the plastic hose.
16.4 Apply a slight pressure to push the plastic hose inwards to the stop.
16.5 Open the water volume regulator ( Work step 11.2 ).
16.6 Mount the cover plate.
17. Fault Correction
If you are unable to correct a fault or if the fault is not described in the fault correction
section, please inform our customer service department!
Fault Cause Remedy
Water does not flow – Water supply interrupted
➯
Restore it
– Water flow regulator closed ➯ Open it
– Solenoid valve faulty
➯
Replace it
– Opto-sensor faulty
➯
Replace it
– Electronic module defective
➯
Replace it
Water flows conti-
nuously – Solenoid valve dirty
➯
Clean it
– Solenoid valve faulty
➯
Replace it
Water flow too weak – Water volume regulator not fully
opened
➯ Open it
– Supply pressure too low
➯
Check it
– Flush volume adjustment incorrect ➯ Adjust it
Water flow too large – Flush volume adjustment incorrect
➯
Adjust it