2.4. Chimney connector
-
The appliance must be as close as possible to the
chimney. Avoid horizontal flue connection pipes which
can dangerously restrain functioning of the appliance.
The connector pipe must be either 24 ga. black painted
or blued steel or 316 grade 20 ga. stainless steel or 1
mm vitreous enamelled steel, with a maximum diameter
of 127 mm (5" O.D.). Single wall pipe may be utilized
being careful to maintain clearances to any combustible
surface.
Once the stove has been properly installed the chimney
draught must be checked with a draught meter.
If the chimney draught is excessive or irregular, a
draught stabilizer (barometric damper) must be
installed to the connector pipe.
2.5. Mounting the levelling feet
Fit the 4 screws and the 4 caps supplied (on the burner)
into each leg of the stove (# 4, p. 13).
2.6. Smoke exit at the top
Figure 6
-
Remove the internal baffle (fig. 14, p. 8).
-
Fit the blanking plate and the support on the top,
ensuring there is a good seal.
-
Fix the sealing rope in the groove on the rear and fit
the flue spigot using the two bolts and washers
supplied, ensuring there is a good seal.
-
Replace the internal baffle (fig. 15, p. 8)
2.7. Smoke exit at rear
Figure 7
-
Remove the internal baffle (fig. 14, p. 8).
-
Set the blanking plate with the flue pipe on the top,
ensuring that it is leaktight.
-
Set the ceramic rope in the groove and fixe the flue
collar with 2 screws and ring supplied at rear.
-
Reinstall the internal baffle (fig. 15, p. 8).
2.8. Casing assembly
Natural stone
: As the stones are easily stained it is
recommended to wear gloves during handling.
Figure 8
➀
- Remove the pin of regulator,
➁
- Remove the rear panel,
➂
- Remove the lateral supports,
➃
- Fit the sides panels by sliding and replace the lateral
support (don’t locking). Adjust the side panels with
regard to upright above locking,
Replace the rear panel and the pin.
Figure 9
Natural stones
: You must glue, under neath the
stone, the ceramic rope which is supplied.
Enamelled panel
: The top neck line must be towards
the back.
6
Technical manual “954”
“Le Beffroi” ref. 174 10 54
Installation instructions
1
2
3
4
5
2
6
5
Figure 6 - Smoke exit from top
Figure 7 - Rear flue outlet
2
3
4
1
Figure 8 - Side panels assembly
