pag8
Chapter 2 Installation Guide
2.1 Safety Warning
The product must only be installed by qualified persons, according to the local safety standards and
regulations. Fracarro Radioindustrie is free from all civil and criminal responsibilities due to breaches of
the current legislation derived from the improper use of the product by the installer, user or third parties.
The product must be used in full compliance with the instructions given in this manual in order to protect
the operator against all possible injuries and the product from being damaged. Do not open the product
container,dangerous voltage parts can be accessible when opening the packaging.
2.2 Installation warnings
●
The product must not be exposed to any dripping or splashing and thus it should be installed indoors
and in a dry location.
●
Humidity and condensation could damage the product. In case of condensation, wait until the product is
dry before using it.
●
Handle the product carefully. Impacts can damage the product.
●
Leave enough space around the product to ensure sufficient ventilation. Excessive temperatures and/or
an overheating may affect the performance and the life of the product.
●
Don’t install the product above or near any heat sources, in dusty places or where it might come into
contact with corrosive substances.
●
In the event that the unit is fixed to the wall, use the proper screw anchors suitable to the characteristics
of the fixing support.
●
The wall and the anchoring system must be able to support at least 4 times the weight of the unit.
●
Attention: to avoid being hurt, the unit must be fixed to the wall/floor in accordance with the installation
instructions.
●
For "PERMANENTLY INSTALLED APPLIANCES", an easily accessible cutting device must be
added to the exterior of the appliance; for "APPLIANCES WITH A POWER PLUG", the socket must
be installed close to the appliance and easily accessible.
●
The product must be connected to the earth electrode of the antenna system, in accordance with
standard EN60728-11. The screw arranged for this scope is marked by the symbol.
It is recommended to comply with the provisions of the standard EN60728-11 and to connect this screw to
the main earth node of the plant (do not connect to intermediate points).