FPM Agromehanika 627 152, Сборка / Эксплуатация / Техническое обслуживание, Список запасных частей

Страница: 14 / 24

Page 14
ASSEMBLY
FPM Boljevac
For easy transport, the rotary rake is supplied with the tines, tine brackets and safety guards
unattached. To assemble the unattached parts, proceed as follows:
Tine bracket assembly (Figure 1)
Insert the tine bracket (S) into the oscillating
part of the rotor (L) and secure it using two
spring bolts (G) (Ø 12x50 and Ø 7x60).
IMPORTANT: Place the spring bolts so that
the slots create a 180º angle and that the
direction of the slot is opposite to the direction
of rotor rotation, as shown in Figure 1.
Spring tine assembly (Figure 2)
The spring tines (A) are attached under the
supports (E) so that the tine arms are tilted
opposite to the direction of rotation of the tine
brackets (see directional arrow).
The spring tines are secured to the supports
using the screw (B) (M12x65), self-locking nut
(G) (M12), washer (C) (Ø 13x35x5), spring
washer
(F) and tine holder (D).
Make sure that all parts are properly secured
(see Figure 2).
Safety guard assembly (Figure 3)
Fit the supports (K) and (L) onto the frame
plate (F) using the screw (M) (M14x30), as
shown in Figure 3.
The front guard bracket (A) and (B) is
attached to the front frame end using the
screw (P) (M10x30). The plate (Q) is attached
to the front frame side.
On the front brackets (A) and (B) and the rear
brackets
(L) and (K), place bumper rods (C) and (E) in
their bearings and secure them from falling
out using the lock (H).
The reflex reflectors are attached to the
bumper rods with a recessed-head screw
(M5x25) and self-locking nut (M5) as
follows: the red reflectors (S) to the rear
and the white ones to the front on the
brackets (A) and (B) (Figure 3).