22
U35 FPI Direct Vent Gas Insert
REMOVING VALVE
1) Shut off the gas supply.
2) Remove the louvers (and bay door if it is on).
3) Open the flush door and remove the door.
4) Remove the logs and brick panels if in-
stalled.
5) Straighten the adjustment wire under the
firebox base.
7) Lift the Burner/Rear Log Support assem-
bly up and away from the orifice.
Burner Orifice
Lift Burner/Rear Log Support assembly up
and away from the burner orifice.
MAINTENANCE
13) Disconnect green wire from power cord.
Replacing fan:
Reverse above steps.
Seal fan access panel using high temper-
ature silicone (sparingly).
Burner/Rear Log
Support Assembly:
After removing the
screws slide to the
left to remove the
assembly from the
firebox base.
Left Side Burner
Bracket
Straighten adjustment wire.
6) Remove the Burner/Rear Log Support as-
sembly by removing the 2 screws (1 on
each side) and sliding the assembly to the
left to free the bottom brackets from the
screws on the firebox base.
10) Unplug the wires from the fan motor (from
inside the stove).
11) Remove the 2 screws from the fan bracket.
12) Pull Fan Assembly forward, to disenagage
the fan clip on the rear wall. Then lift the Fan
Assembly up and pull through firebox open-
ing.
