Operating Instructions
4
Operating Instructions
5
Please restart the splitter when change EDID mode!
Front Panel
Rear Panel
Power ON/OFF
1
Indicator of Loop out
2
Indicator of out
3
Reset button
5
Indicator of Power
6
DIP switch for EDID setting
4
RS232 port
7
Output1 port (RS232 pass-though)
1
1
2
3
4
2
2
5 6
3
5
POC port
Note:
Connecting and operating
1) Connect the HDMI input source into HDBaseT splitter.
2) Connect HDBaseT splitter and Receiver over Cat6 cable, The Cat6 cable must follow
EIA-TIA 568b standards.
3) Connect the HDMI output of Receiver to the HDMI Display.
HDMI Input port
Main power
HDMI Output port
2
4
6
Output2,3&4 port
EDID
0 0
0 1
1 0
1 1
4K@60Hz
、
YCBCR420
、
3D
、
DOLBY5.1
1080P@60Hz
、
2CH
1080P@24Hz
、
3D
、
DOLBY5.1
4K@30Hz
、
2CH
7) To get on the ethernet,pls connect as below steps:
1.Connect ethernet cable into ethernet port on HDBaseT splitter.
2.Connect ethernet cable with TV and ethernet extender receiver.
Note:1.The ethernet function is designed for ethernet compatible receiver units only.
2.Only output1 with ethernet function.
8) Copy EDID function
Copy the EDID of the sink which connected the loop HDMI.
4) Connect 4pcs IR TX cables to the IR-TX sockets on the splitter and connect 4pcs IR RX cables
to the IR-RX sockets on the splitter.
5) Connect IR RX cable to IR-In port of Receiver, connect IR TX cable in to IR-Out port of Receiver.
6) Power up all units, the splitter,Receiver
,
sources and displays.
