T3500 Plus Tethered Power System for Drones
Operation Caution
©
2019 FOXTECH All Rights Reserved
5
The second step (connection):
1. Check if the winch control button is in the 0 position. If not, please adjust it to the 0 position. Otherwise,
the winch cable will not be pulled out ,and the system will alarm, adjust the winch control knob to 0 position
to relieve alarm.
2. Check whether the air switch is off, if it is off, please turn on. It defaults to OFF in the process of
transporttation.
Dial the main switch to ON-Turn on
3. Turn on the main switch, the display will light up, power is supplied to the winch,the cable is in no-power
state, (the cable outlet count starts from the power-on state of the winch). Insert the 400vdc cable connector
into the onboard power module interface,the onboard power supply module is connected to the battery in
parallel, then connect it with ESC (motor), as shown in the figure,the hook is attached to the carbon plate or
other fixed position.
Winch control knob- Max.6.5,excessive
tension will lead to overload failure,need to
reset by main switch.
Onboard power input and output terminals have been differentiated.the cable connector only
matches the onboard power input terminal and does not result in reverse insertion, except for the
products that not belong to our company.
It is also possible to connect the cable to the onboard power supply module first and then turn on the
main switch.
Note that the cable hook must be attached to the force bearing point of the aircraft,otherwise that
may break the aircraft structure, result in disconnection of power plug, and a sudden power failure
will cause the aircraft crash, all at your own risk.
