T3500 Plus Tethered Power System for Drones
Operation Caution
©
2019 FOXTECH All Rights Reserved
2
Product List:
- 4KW tethered box.
- 3.5KW onboard power supply.
- 1x 220Vac input cable, 16A plug by default (if using 16A to 10A socket, please note that the full power of
socket is only 2.2KW)
This device can not work on rainy days,otherwise the cable will conduct electricity and burn the
motherboard. For all the consequences arising from your own!
The onboard power supply of this equipment is burned due to overload or failure to follow the
operating instructions, that is not covered by the warranty.
This device is forbidden to be used in the sun exposure. The operation panel will absorb heat and
cause heat dissipation problem. If the cable burnt out due to this, that is not covered by the warranty.
This equipment box can only be dragged on a flat surface, it is better to ask two people to carry the
box to avoid damage to the wheels, that is not covered by warranty.
No bumping and water entering during the transportation of this equipment, it must be packed in
aviation aluminum box during transportation or take damping treatment, the warranty does not cover
eeeqqquuuiiipppmmmeeennnttt damage.
Warning
1.The battery interface of the onboard power supply module must be connected with the cable
connector first, then plug in the battery to prevent the ignition of the onboard power chip.
2. When the aircraft took off to 5m altitude by using the backup battery, turn on the cable power switch
of the tethered system; When the aircraft descended to 5m above the ground, the cable power should
be cut off in time.
3. The cable pulling and feeding speed is controlled in 3-4 gear. When pulling the cable, must keep the
cable taut to prevent the winch from being entangled by the cable. The raising and descent speed of
the aircraft is 1m/s.
4. It is forbidden to touch the cable directly (with insulated gloves) by hand when the cable power is
turned on, the high voltage 400vdc is injured, and the consequences arising from your own.
5. The on-board power supply module must be equipped with backup batteries, fully charged before
each flight to prevent aircraft from being forced to drop due to power-off, which will damage the
equipment.
6. This equipment is forbidden to be powered for a long time but never used. To prevent the cable from
being overheated and burned, the drone is required to fly in a 100m altitude.
7. Do not change the cable power voltage setting, if not, burning the onboard power supply module is
at your own risk.
Cable Power:
Long press 3s to turn on, long press 3s to turn off; short press 1s to enter the voltage
setting interface, long press 3s to confirm the value.
