42
it is generally not recommended to change the IP of the
computer of the remote control.
8. V30 Video Transmission Module
Operation
8.1 V30 Parameters Configuration
1. Connecting the device
The V30 or ground end device can be configured via serial port.
V30 is connected to the power supply and serial port of the
equipment. Start T30 directly and opens the
serial port
assistant
.
2. Power on the device and wait for device initialization
About 3s after the device is powered on, the CPU light flashes,
indicating the successful device initialization.
3.
Enter serial port configuration mode
The device is connected to the computer through the serial
port. In the computer, by using serial port tool, set the baud
rate as 115200bps, data bit as 8, stop bit as 1, no check bit, no
flow control.
After opening the serial port colume, enter "+++" in the serial
port tool, the terminal will display <Enter Config Model>,
indicating that the serial port configuration mode is entered, as
shown in the figure below.
Note:
The T30 is matched with COM6 and the V30 is
matched with the port number of the tool. You must not send a
newline return.
