9
To assign a preset, perform the following:
1.
Press and hold the P1 or P2 button for 5 seconds. Notice the top status line of the TX9
display will change to: “SEL SND/VOL PRESS P1” or “SEL SND/VOL PRESS P2”.
2.
Use the sound selector buttons to highlight the sound you wish to have set on the
particular preset.
3.
Use the volume buttons to set the desired volume level for the preset.
4.
Push P1 or P2 a final time, depending upon which one you are setting.
To begin playback of a preset, simply push the P1 or P2 button while operating the Scorpion X1C
remotely. The Scorpion X1C will immediately switch to that sound and volume level.
3.
Auxiliary Jack Function
The Scorpion X1C is equipped with an auxiliary jack labeled “AUX”. The purpose of this jack is to
allow for the connection of certain external devices, such as the FOXPRO
®
Jack-in-the-Box or
Jack-Attack Decoy and to be able to turn these on and off with the TX9 remote control
transmitter. However, there are some strict electrical limits involved with this jack. If these
limits are exceeded, damage to your Scorpion X1C will result. This damage is not covered by the
warranty.
The electrically inclined will want to know that the jack is connected to the drain of an internal
Field Effect Transistor with a maximum current rating of 100mA. The “tip” polarity of the 3.5mm
jack is positive, while the sleeve is negative. If the external device is connected with the polarity
reversed, an internal protection diode within the FET will conduct, causing the device to stay on
constantly. The maximum voltage applied to this jack must never exceed 15 volts. Typical uses
for this jack would be to control the FOXPRO
®
FOXJACK or Jack-Attack Decoy, or to start and
stop a video recorder. Instructions on connecting various devices to the “AUX” jack are beyond
the scope of this manual. You are urged to seek help from a knowledgeable professional before
connecting any unapproved device to this jack. Remember that damage to your Scorpion X1C
caused by improper use of the “AUX” jack is not covered by the warranty, nor will FOXPRO
®
be
liable for damage to any device connected to this jack.
4.
Using External Speakers
The Scorpion X1C is equipped with two external speaker jacks. The jacks are labeled “Spkr A”
and “Sprk B” and are located on the right side of the caller housing (see image on next page). By
default, the Scorpion X1C is setup so that the audio output is directed to the internal speaker
only. In order to have the audio directed to the external speaker jacks, you must change the
position of a shunt inside the Scorpion X1C (see section 4-2).
You can find a complete selection of additional speakers to purchase on the FOXPRO website.
Содержание Scorpion X1-C
Страница 1: ......
