Foxpro HELLFIRE, Инструкция по эксплуатации

Страница: 19 / 20

19
•
Always maintain clear line of sight between the remote control and the Hellfire. Any
obstructions—no matter how significant or insignificant—can adversely affect the
radio signal.
•
Try to keep the remote control approximately six inches away from your body, gun
barrel, and metal shooting sticks as these things can detune the remote control.
•
Hold the remote control vertically with the antenna pointing skyward.
•
Avoid using the device remotely when you are near power lines, cellular phone
towers, and radar (such as near airports or military installations).
•
Try to elevate the caller off of the ground by approximately three feet. This can
greatly maximize your overall remote control range.
•
Try to avoid situations where the Hellfire is placed at a lower elevation than the
remote control—the caller should always be higher.
•
If you are using the Hellfire remotely from a long distance, be sure to allow enough
time for device reaction before sending multiple signals. For example, if you request a
sound change, consider the amount of time from radio transmission from the remote
to the Hellfire until that signal is turned into a change in operation that you are able
to perceive. It will not always be instantaneous and may take a second or two before
a change in operation is detected from your vantage point. Mashing down button
after button can get the device into a state of confusion which could result in
undesirable results.
11. FCC & IC Information
FCC Information
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that the interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet or circuit different that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation of this device. Modifications not expressly approved by the
manufacturer could void the user’s authority to operate the equipment under FCC rules.