Foxpro HELLFIRE, Инструкция по эксплуатации

Страница: 11 / 20

11
•
Make sure that the rechargeable battery pack is installed in the Hellfire
properly.
•
Disconnect any/all accessory devices that may be attached to the Hellfire
prior to charging. This includes external speakers, auxiliary devices, and USB
cables.
•
Follow the included instructions for the particular FOXPRO charger that you
are using.
•
Connect the approved FOXPRO charger to the charger jack on the Hellfire
and attach the transformer to the appropriate outlet.
•
For maximum charge efficiency, we recommend charging your Hellfire in
temperatures ranging from 40°F to 85°F (5°C to 30°C).
4. Auxiliary jack Function
The Hellfire is equipped with an auxiliary jack labeled “AUX”. The purpose of this jack is to allow
for the connection of certain external devices, such as the FOXPRO Jack-in-the-Box or Jack-
Attack Decoy and to be able to turn these on and off with the TX9 remote control transmitter.
However, there are some strict electrical limits involved with this jack. If these limits are
exceeded, damage to your Hellfire will result. This damage is not covered by the warranty.
The electrically inclined will want to know that the jack is connected to the drain of an internal
Field Effect Transistor with a maximum current rating of 100mA. The “tip” polarity of the 3.5mm
jack is positive, while the sleeve is negative. If the external device is connected with the polarity
reversed, an internal protection diode within the FET will conduct, causing the device to stay on
constantly. The maximum voltage applied to this jack must never exceed 15 volts. Typical uses
for this jack would be to control the FOXPRO ® Jack-in-the-Box or Jack-Attack Decoy, or to start
and stop a video recorder. Instructions on connecting various devices to the “AUX” jack are
beyond the scope of this manual. You are urged to seek help from a knowledgeable professional
before connecting any unapproved device to this jack. Remember that damage to your Hellfire
caused by improper use of the “AUX” jack is not covered by the warranty, nor will FOXPRO ® be
liable for damage to any device connected to this jack
5. Using an Additional Speaker
The Hellfire is equipped with an external speaker jack. This jack allows you to connect an
additional speaker. When you are using an external speaker, be advised that the main speaker
will continue to play—there is no way that you can disable to main speaker.
5-1 Connecting an External Speaker
The external speaker jack accepts a standard 3.5mm plug. When choosing an external speaker,
make sure that it has an impedance rating of 8-ohms.
NOTE: Be sure that the Hellfire is turned
off prior to connecting an external speaker!