2
transmitter conveniently slides into the Dead Bone game call
itself. Remove the transmitter from the Dead Bone by sliding it
out of its storage compartment. The transmitter requires a
single 9V battery. To install the 9V battery, remove the battery
door from the rear of the transmitter, connect the battery to the
battery connector, and then replace the door.
Operation
Turning on the Dead Bone
Turn on the Dead Bone by moving the power switch to the on
position. You will observe the green power indicator
illuminating when turned on. If the batteries are getting low,
the indicator will begin to blink.
Turning on the Dead Bone Transmitter
Turn on the Dead Bone transmitter by holding down the power button for about 1-2 seconds. The indicator
on the transmitter will illuminate green. When the transmitter begins to get low, the green indicator will flash.
Playing a Sound
To play a sound, push one of the 15 sound
selector buttons a single time. To increase
the volume, use the volume up button (to
decrease, use volume down). There are 20
volume steps available. The transmitter
does not indicate what volume step you
are current at during operation. To switch
to a different sound, push one of the other
sound selector buttons while the current
sound is playing. When a sound is
playing, it will continue to loop that
sound until you either mute it or switch to
a different sound.
Mute Control
To mute the current sound, push the mute
button a single time. When muted, the
indicator on the transmitter will
illuminate red. To un-mute the sound,
push the mute button again and the
indicator returns to green.
Playing Two Sounds Simultaneously
Start playing a sound as described
previously. Next, push the add button a
single time. The indicator switches to an
amber color to indicate that it is waiting
for you to select the second sound. Push
one of the sound selector buttons to activate the second sound. Notice that the indicator returns to green and
both sounds will now be playing. When using the mute button while two sounds are playing, be aware that
both sounds will mute simultaneously. When you adjust the volume, the volume for both sounds is adjusted
simultaneously. To change the second sound, push the add button (indicator turns amber) and then push a
