Foxfury Lighting Solutions TAKER R40, Руководство по эксплуатации продукта

Страница: 15 / 16

15
DRILLING TEMPLATE
Use this template to drill the required holes for mounting the Taker R40 to a
riot shield.
1. Begin by cutting this sheet out and taping and centering it (or vertically
aligning it to the desired location).
2. Drill two (2) pilot holes that are 50 mm apart using a
1
/
8
" drill bit (use the
smallest circle ( ) as a guide to drill the pilot hole).
3. Using the recommended
12
/
64
" or 7mm drill bit, drill two (2) holes that are 50
mm apart (approx 2 in).
NOTE: Image above is to size and holes are 50 mm apart.
1
2
3
INSTRUCTIONS
INSTRUCTIONS:
Use this template to drill the required holes for mounting
the Taker R40 to a Riot shield.
1. Begin by taping this sheet to the shield and centering it (or
vertically aligning it to desired location).
2. Drill two pilot holes that are 50mm apart using a
1
/
8
” drill bit
(use the smallest circle ( ) as a guide to drill the pilot hole).
3. Using the recommended
17
/
64
” or 7mm drill bit, drill two
holes that are 50mm apart (approx 2”).
NOTE: Image above is to size and holes are 50mm apart.
DRILLING TEMPLATE
FOR USE WITH THE TAKER R40 (P/N 700-331)
INSTRUCTIONS:
Use this template to drill the required holes for mounting
the Taker R40 to a Riot shield.
1. Begin by taping this sheet to the shield and centering it (or
vertically aligning it to desired location).
2. Drill two pilot holes that are 50mm apart using a
1
/
8
” drill bit
(use the smallest circle ( ) as a guide to drill the pilot hole).
3. Using the recommended
17
/
64
” or 7mm drill bit, drill two
holes that are 50mm apart (approx 2”).
NOTE: Image above is to size and holes are 50mm apart.
DRILLING TEMPLATE
FOR USE WITH THE TAKER R40 (P/N 700-331)