Foxfury Lighting Solutions 200-1200, Руководство по эксплуатации продукта, Страница: 15 / 22

15
1. Unscrew all three (3) Caps from the three (3) different parts of the Nomad
®
Transformer
®
(Light Head, Tripo-Scope
®
, and Power Pack).
2. Once all Caps are removed, place the Tripo-Scope
®
onto the Power Pack
(male end), line up the I, II, and III marks (shown on p. 13). Once aligned,
tighten the Locking Ring to secure the Tripo-Scope
®
to the Power Pack.
The folding Tripo-Scope
®
Legs are now ready to deploy .
3. Unfold each Tripo-Scope
®
Leg and make sure they are locked in place by
the Leg Locks (see "Transformer
®
Reference Guide" on p. 3 for location).
4. Open the Protective Light Cap to raise the Tripo-Scope
®
Poles slightly
(do NOT raise the poles all the way, as the Light Head still needs to be
installed). Place the Light Head on top of the Tripo-Scope
®
Pole. Line up the
I, II, and III marks then tighten the Locking Ring to secure the Light Head to
the Tripo-Scope
®
.
Keep the Light Panels as they are for a 360 configuration, or open the
Light Panels for a Directional configuration. Then, adjust the Sliding
Diffuser Lens to either Area or Spot lighting (see p. 9).
Adjust the angle and swivel position of the Light Head by loosening the
Tilt Adjustment Knob to the desired orientation and then re-tighten
(see p.10).
NOTE: The Nomad
®
Transformer
®
Extension (P/N 85-600) can be used
between Light Head and Tripo-Scope
®
. This will make Transformer
®
15.7 ft (478 cm) tall.
5. Elevate the Light Head to desired height by raising the Tripo-Scope
®
Poles.
Tighten the Tripo-Scope
®
Tightening Rings (clockwise) to hold the poles at
desired height (see p.16 and 17).
IMPORTANT! To reposition, loosen the Tightening Rings, bring the
Tripo-Scope
®
Poles down again, and turn the Light Head. Turning the
Tripo-Scope
®
Poles against each other can cause permanent damage.
In case of heavy wind or extreme weather conditions, place stakes
through the Anchor Points (only on dirt surfaces) to hold down the
Nomad
®
(see "Transformer
®
Reference Guide" on p. 3 for location). The
Tripo-Scope
®
Legs can also be reinforced by activating the Leg Locks
(shown on p. 14).
THE NOMAD
®
TRANSFORMER
®
IS NOW READY FOR USE!
WARNING!
The Nomad
®
Transformer
®
is heavy once fully assembled. If you need to move
it once it is deployed, use a Team Lift approach with at least two people, OR
disassemble and then reassemble at new location.
2
3
4
5
1