Foxfury Lighting Solutions 200-1200, Руководство по эксплуатации продукта, Страница: 13 / 22

13
This method allows the unit to be quickly deployed and be used in very tight
spaces or on table tops.
Begin with the Light Head and Power Pack ONLY.
1. Remove the two (2) Caps from the Light Head and Power Pack (for
location see p. 4). Then place the Power Pack on level ground.
2. Install the Light Head onto the Power Pack and line up the I, II, and III
marks (printed underneath the Locking Ring of the Light Head and Power
Pack — shown above). Once aligned with the correct marks, tighten the
Locking Ring on the Light Head to secure both pieces together.
Once completely installed, press the Power/Mode Switch to turn the
Nomad
®
ON.
Adjust the tilt and direction of the Light Head panels as necessary.
Keep them as they are for a 360 configuration or, open them for a
Directional configuration. Then, adjust the Sliding Diffuser Lens to
either Area or Spot lighting (see p. 9).
NOTE: The Nomad
®
Transformer
®
Extension (P/N 85-600) can be used in
between Light Head and Power Pack (see p. 16).
DEPLOYING THE NOMAD
®
WITH NO
TRIPO-SCOPE
®
1 2
2
1