Foxconn 6497MC series, Руководство пользователя

Страница: 16 / 45

Chapter 2 Installation Instructions
12
Other Connectors
This motherboard includes connectors for floppy devices, IDE devices, Serial
ATA devices, USB devices, IR module, and others.
FDD Connector: FLOPPY
This motherboard includes a standard FDD connector, supporting 360K, 720K,
1.2M, 1.44M, and 2.88M FDDs.
IDE Connectors: PIDE, SIDE
These connectors support the provided Ultra DMA 133/100/66 IDE hard disk
ribbon cable. Connect the cable’s blue connector to the primary
(recommended) or secondary IDE connector, then connect the gray connec-
tor to the Ultra DMA 133/100/66 slave device (hard disk drive) and the black
connector to the Ultra DMA 133/100/66 master device. If you install two hard
disks, you must configure the second drive as a slave device by setting its
jumper accordingly. Refer to the hard disk documentation for the jumper
settings.
Attention:
Ribbon cables are directional, therefore, make sure to always
connect with the cable on the same side as pin 1 of the PIDE/SIDE
or FDD connector on the motherboard.