32
3
Integrated Peripherals
► OnChip IDE Device / Onboard Device / SuperIO Device / USB Device Setting
Press <Enter> to go to relative submenu.
onChip IDe Device
► IDE HDD Block Mode
If your IDE hard drive supports block mode, select [Enabled] for automatic detection of the
optimal number of block read/write per sector.
► IDE DMA Transfer Access
[Disabled] : to disable DMA transfers for all IDE drives. They will revert to PIO mode transfers.
[Enabled] : to enable DMA transfers for all IDE drives. The proper DMA mode will be detected
at boot-up. If the drive does not support DMA transfers, then it will use PIO mode instead.
Recommend leaving this BIOS feature at the default [Enabled] setting. You should only disable
Phoenix - AwardBIOS CMOS Setup Utility
Integrated Peripherals
►
OnChip IDE Device
[Press Enter]
Item Help
► �nboard Device
[Press Enter]
► SuperI� Device
[Press Enter]
Menu Level ►
► USB Device Setting
[Press Enter]
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General �elp
F5: Previous Values F7: �ptimi��ed Defaults
Press Enter
Phoenix - AwardBIOS CMOS Setup Utility
OnChip IDE Device
IDE HDD Block Mode
[Enabled]
Item Help
IDE DMA Transfer Access
[Enabled]
On-Chip Primary PCI IDE
[Enabled]
Menu Level ►
IDE Primary Master PIO
[Auto]
If your IDE hard drive
IDE Primary Slave PIO
[Auto]
supports block mode
IDE Primary Master UDMA
[Auto]
select Enabled for
IDE Primary Slave UDMA
[Auto]
automatic detection of
On-Chip Secondary PCI IDE
[Enabled]
the optimal number of
IDE Secondary Master PIO
[Auto]
block read/writes per
IDE Secondary Slave PIO
[Auto]
sector the drive can
IDE Secondary Master UDMA
[Auto]
support.
IDE Secondary Slave UDMA
[Auto]
*** On-Chip Serial ATA Setting ***
On-Chip Serial ATA
[Enhanced Mode]
SATA PORT Speed Settings
[Force GEN II]
x PATA IDE Mode
Primary
SATA Port
P1,P3 is Secondary
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General �elp
F5: Previous Values F7: �ptimi��ed Defaults
Enabled
